1、施工前應保證下層溫度高于露點溫度3℃，施工過程中應保持延續攪拌；
1, the construction should ensure that the basic temperature is higher than the dew point temperature of 3 degrees C, the construction process should be kept continuous mixing;

2、若檢驗時發現涂層有鼓泡、漏噴等缺陷，則必要立即進行修補；
2, if the test found that the coating has a bubble, leakage and other defects, the need for immediate repair;

3、如缺陷部位發現離噴涂時間較短（≤6h），可對缺陷涂層外觀進行打磨，清理后直接進行二次噴涂；

3, such as the defects found from the spraying time is short (less than 6h), the defects of the coating surface grinding, cleaning up directly after the two spraying;

4、假如缺陷部位發現離噴涂時間較長（＞6h），則應對缺陷涂層外觀（向外擴展5～10cm范圍）打磨清理后，施作專門的處理劑，然后采用專用修補設備噴涂LM復合防腐屋頂防水涂料并修補刮平（河北人事考試網站），使整個涂層延續、致密、均勻。
4, if the defective parts found from the spraying time is longer (more than 6h), then deal with the defects of the coating surface (extended range of 5 ~ 10cm) grinding after cleaning, apply special treatment, and then use special equipment repair sprayed LM composite waterproof anti-corrosion coating and repair, scraping, make the whole continuous, dense and uniform coating.

5、雨天不得施工；四級以優勢力不宜施工；
5, rainy days shall not be constructed; more than four wind construction;

6、施工現場應安全用電，杜絕火源并配備好響應的消防器材。
6, the construction site should be safe use of electricity, put an end to fire and equipped with appropriate fire equipment.